Problem solved! As many of you stated since my last picture, the bend in the wire was in the wrong place.
Not that the assistant or ortho did anything wrong in bending it, but the wire had slid to one side and this caused the bends to all be in the wrong place. (slid to the right in the picture below)
The ortho looked at my lower teeth and remembered that they had been straight by the end of my appointment last month. He grabbed hold of the wire with pliars and shoved it around about 1/4 of an inch. The tooth slid into a better position right away. He had the assistant put a stop on the wire to prevent that from happening again. He told me that this should fix it up close to perfect. Anything that isn't perfect in January can and will be fixed with retainers (WHAT DID HE SAY???!!!)
Then, this is the very cool part, he told me that they would make molds of my uppers today for my
debonding in January!!!
Funny, I was in such bliss that I hardly noticed the impression gunk running down my throat!
I got to pick out my retainers. I chose a bonded lower and a hawley upper that will be neon purple with gold sparkles. That was fun!!
Here's a picture of the difference just 1 hour after he pulled the wire round to it's
proper place:
Here's the picture of it after it went out of line. It still looked
exactly like this before my appointment today:
You can really see the wire difference. I promise you that the wire was not removed or bent in any way...that's how far it had slid out of position.
I am GIDDY right now, knowing that I will be debonded on January 11!!! Was hoping for it before Christmas so I could eat the toffee that I make every year, but I will just put some away for myself and will enjoy the hell out of it 2 weeks later!